[Intelligent Auto]
The focus area may not light up during continuous shooting or when the shutter button is pressed all the way down at once.
When the Still/Movie/S&Q dial is set to (Movie) or S&Q (S&Q Motion) or during movie shooting, [Tracking] cannot be
selected for [ Focus Area].
[Spot: XS] under [ Focus Area] cannot be selected when shooting in the APS-C size. Also, when [ Focus Area] is set to
[Custom 1] - [Custom 3], the size of the focus frame cannot be set smaller than that of [Spot: S].
Examples of the focusing frame display
The focusing frame differs as follows.
When focusing on a larger area
When focusing on a smaller area
When [ Focus Area] is set to [Wide] or [Zone], the focusing frame may switch between “When focusing on a larger
area” and “When focusing on a smaller area” depending on the subject or situation.
When [ Focus Area] is set to [Custom], the focusing frame may switch to “When focusing on a smaller area” if
either the vertical or horizontal side of the focus area is longer than the side of the focusing frame for [Spot: XL].
When you attach an A-mount lens with a Mount Adaptor (LA-EA3 or LA-EA5) (sold separately), the focusing frame for
“When focusing on a smaller area” may be displayed.
When focus is achieved automatically based on the whole range of the monitor
When you use a zoom function other than the optical zoom in the still image shooting mode, the [ Focus Area]
setting is disabled and the focusing frame is shown by the dotted line. The AF operates with priority on and around
the center area.
To Next Page
Loading...
