Help Guide
Interchangeable Lens Digital Camera
ILCE-9M3 α9III
Cont. Bracket
Shoots multiple images while automatically shifting the exposure from base to darker and then to lighter. You can select
an image that suits your purpose after recording.
Menu item details
Exposure Value:
Sets the amount by which the exposure value is adjusted during bracketing shooting.
Number of Shots:
Sets the number of images to shoot during bracketing shooting.
To set the drive mode using MENU
When the drive mode dial is set to (disabled), you can set the drive mode in MENU.
MENU → (Shooting) → [Drive Mode] → [Drive Mode] → [Cont. Bracket].
Hint
The last shot is shown on the auto review.
Note
When [ISO AUTO] is selected in [Manual Exposure] mode, the exposure is changed by adjusting the ISO value. If a setting other
than [ISO AUTO] is selected, the exposure is changed by adjusting the shutter speed.
When the exposure is compensated, the exposure is shifted based on the compensated value.
Bracket shooting is unavailable in the following shooting modes:
[Intelligent Auto]
When [ Picture Profile] is set to other than [Off]
Select (Bracket) by turning the drive mode dial.
Turn the drive mode dial while holding down the drive mode dial lock release button.
1
MENU → (Shooting) → [Drive Mode] → [Bracket Settings] → [Bracket Type] → [Cont. Bracket] → select
the desired exposure value and the number of images you want to shoot.
When setting to record two images, you can select whether to adjust the exposure to the + (over) or - (under)
side.
2
Adjust the focus and shoot the image.
Keep pressing and holding the shutter button until bracket shooting is finished.
3
To Next Page
Loading...
