Help Guide
Interchangeable Lens Digital Camera
ILCE-9M3 α9III
Preset Focus/Zoom
You can move the focus position (the distance to the subject in focus) and zoom position (angle of view) to preregistered
positions using custom keys. You can register 5 focus position/zoom position combinations.
To register the focus position/zoom position
To recall the focus position/zoom position
Press the key to which you have assigned [Preset Focus/Zoom] on the shooting screen to recall the registered focus
position and zoom position.
To check the registered settings
You can check the registered focus position and zoom position by selecting MENU → (Focus) → [AF/MF] →
[Preset Focus/Zoom] → desired number.
If you add a check mark to [Recalls only zoom position.] on the [Preset Focus/Zoom] screen, only the zoom position
and not the focus position will be recalled when you recall the number.
Hint
You can also assign [Preset Focus] to [Function Ring(Lens)]. In this case, move and hold the function ring of the lens on the
shooting screen to register the focus position and zoom position, and briefly flick it to recall them.
Only the settings for the focus position and zoom position to be registered to the function ring on the lens are registered to [Preset
Focus/Zoom 6] under [Preset Focus/Zoom].
Note
You can register zoom positions only within the range of the optical zoom.
The focus position and zoom position cannot be recalled while the shutter button is pressed half way down.
To use the [Preset Focus/Zoom] function in the movie mode, set [AF Assist] to [On].
If a prime lens is attached, only the focus position will be registered.
MENU → (Setup) → [Operation Customize] → [ Custom Key/Dial Set.] or [ Custom Key/Dial Set.] →
Assign [Preset Focus/Zoom 1] - [Preset Focus/Zoom 5] to the desired key.
To use the [Preset Focus/Zoom] function, you need to assign the [Preset Focus/Zoom] function to a custom key.
1.
On the shooting screen, press and hold the key to which you have assigned [Preset Focus/Zoom].
The focus position and zoom position at the time that the key was pressed and held will be registered to the assigned
number.
If you register information again to a number to which content has already been registered, the content will be
overwritten.
2.
To Next Page
Loading...
