Sony MVS-3000A System - Configuring the Network

19
Configuring the Network
Preparation
Configuring the Network
When power is turned on, all devices connected to the
MVS system LAN are detected and corresponding settings
are registered.
1 Display the menu.
a Open the Engineering Setup >System >Network
Config menu (7311).
2 Set the group ID.
Network Config menu
a Check the group ID.
In this example, check that the group ID is set to
“1”.
If the group ID is not set to “1”, press [Group ID]
and change the setting.
For details about settings, refer to the User’s
Guide.
3 Detect the connected devices.
a Press [Auto Config].
b Check the message, then press [Yes].
A list of detected devices appears.
4 Register the list of detected devices.
a Press [Define].
b Check the message, then press [Yes].
The list is registered as the network settings when
power is turned on.
Group ID
Auto Config Define
MVS-6520/6530/3000A screen shown.
On the MVS-3000, [DME1] is not displayed.
DME
Control panel
Switcher processor