Sony MVS-3000A System - Saving;Recalling User Settings on Removable Disks

42
Saving Data to Removable Disk
Preparation
Saving/Recalling User Settings on
Removable Disks
You can save customized user default (“Setup” and “Initial
Status”) data to USB flash memory or other removable
disk and recall it when required.
This section describes the procedure for operations for the
“Setup” data file.
You can save register data containing snapshots,
keyframes, macros and other data on a removable disk and
then recall that data.
For details about operation, refer to the User’s Guide.
1 Prepare a removable disk.
For details about configuring a removable disk for use
in the MVS system, see “Setting Up a Removable Disk
for Use” (1 p. 41).
2 Display the menu.
a Open the File >Setup, Init, KMem >Setup menu
(7111).
For operations for the “Initial Status” data file, open
the File >Setup, Init, KMem >Initial Status menu
(7112).
3 Select the target device.
Setup menu
a In the device selection area on the left, select the
target device.
Register: Switcher memory area (RAM)
Local Disk: Internal flash memory drive in the
control panel
Removable Disk: USB-compatible external
storage device (USB memory, etc.)
In this example, select [Register] to save the
customized data stored in the switcher memory area
(RAM).
b In the device selection area on the right, select
[Removable Disk] and then select [SYSTEM]
(default directory).
You can also create an arbitrary directory on the
removable disk.
4 Execute a save or recall operation.
To save data
a Press [t Save].
To recall data
a In the [Removable Disk] list on the right, select the
file you want to recall.
b Press [T Load].
Memo
Memo
Device selection area
T Load t Save
Memo