Sony MVS-6520 - Blind Settings

USO RESTRITO
196
Applying Special Effects (Nonlinear Effect Settings)
No.
Parameter
Adjustment
2
Random
Degree of randomness in
distance moved by each block
3
Angle
Direction of movement
No.
Parameter
Adjustment
1
H
Horizontal center position
2
V
Vertical center position
No.
Parameter
Adjustment
1
Width
Width of partition
2
Random
Degree of randomness in
partition width
3
Angle
Partition angle
No.
Parameter
Adjustment
1
Transition H
Degree of left and right
separation
2
Transition V
Degree of top and bottom
separation
No.
Parameter
Adjustment
1
Rotation
Number of rotations of the blocks
2
Perspective
Degree of randomness in
distance moved by each block
No.
Parameter
Adjustment
1
Top
Amount of movement of top
2
Left
Amount of movement of left
3
Right
Amount of movement of right
4
Bottom
Amount of movement of bottom
No.
Parameter
Adjustment
1
Width
Width of partition
2
Offset
Degree of randomness in
partition width
3
Angle
Starting angle of effect
No.
Parameter
Adjustment
1
H
Position of left and right
separation
2
V
Position of top and bottom
separation
No.
Parameter
Adjustment
4
No.
Width of blocks
5
Phase
Partition position
Chapter
10
DME
Operations
1 Press [Position].
2 Set the following parameters.
3 To set the partition method, press [Partition] and set
the following parameters.
Split Settings
You can set the degree to which the image is split, the split
positions, and other parameters.
Applying the Split effect
Blind Settings
You can set the number of rotations by blocks, the
perspective, the width and position of blocks, the direction,
the center position, and other parameters. There are two
modes: Bar and Wedge.
Applying the Blind effect
1 In the <Mode> group of the Non Linear >Blind menu
(4141.10), select [Bar] or [Wedge].
2 To make transition settings, press [Transition] and set
the following parameters.
1 In the <Mode> group of the Non Linear >Split menu
(4141.11), select the split method.
Single: Leave gaps between splits.
Double: Fill gaps between splits with the same image.
2 Set the following parameters.
Parameter group [1/2]
Parameter group [2/2]
3 To set the partition method, press [Partition] and set
the following parameters.
When Bar was selected in step 1
When Wedge was selected in step 1
To set the wedge center position
When [Wedge] is selected in the <Mode> group, you can
set the wedge center position.
To set the split position
1 Press [Position].
2 Set the following parameters.