Applying Special Effects (Nonlinear Effect Settings)
Degree to which image periphery
expands
Degree of curvature of transition
path
Chapter
10
DME
Operations
Roll Settings
There are four modes: H&V, H, V, and Off. You can select
the turn position, the radius of the turned portion, the
amount and angle of turning, and the input video for the
front and back pages.
Applying the Roll effect
Open the Non Linear >Roll menu (4141.20).
The parameter setting buttons in the Roll menu have the
same items and parameters as those in the Page Turn menu
(
1
p. 199).
Notes
When using a roll effect with one channel, the following
restrictions apply.
•
When the input is, for example, a title in an MKS-6570
or MVE-8000A HD system, parts of the back page other
than the title appear as black.
Cylinder Settings
You can set the degree of winding onto the cylinder, the
radius, the horizontal position of the wound image, and
front and back side output for the image.
Applying the Cylinder effect
In the Non Linear >Cylinder menu (4141.21), set the
following parameters.
Degree to which image is wound onto
the cylinder
Horizontal position of the image
wound onto cylinder
The procedure for selecting the input signal in the <Back
Video> group is the same as for the Page Turn menu
(
1
p. 199).
Notes
When using a cylinder effect with one channel, the
following restrictions apply.
•
When the input is, for example, a title in an MKS-6570
or MVE-8000A HD system, parts of the inner surface
other than the title appear as black.
Sphere Settings
You can set the degree of winding onto the sphere, the
radius, the horizontal position of the wound image, and
front and back side output for the image.
Notes
You cannot monitor the part of a rotating sphere that
corresponds to its axis on the monitor screen.
Applying the Sphere effect
Open the Non Linear >Sphere menu (4141.22).
The parameter setting buttons in the Sphere menu have the
same items and parameters as those in the Cylinder menu
(
1
p. 200).
Notes
When using a sphere effect with one channel, the
following restrictions apply.
•
When the input is, for example, a title in an MKS-6570
or MVE-8000A HD system, parts of the inner surface
other than the title appear as black.
Explosion Settings
You can set the pattern shape and aspect ratio, the center
position, the amount of movement by fragments, the
curvature of the transition path, and other parameters.
Applying the Explosion effect
1
In the <Mode> group of the Non Linear >Explosion
menu (4141.25), select the explosion pattern.
Circle
Rectangle
Star
Heart
Ellipse
2
Set the following parameters.
When Circle was selected in step 1
To Next Page
Loading...
