Notes
Switching on/off reinitializes all frame memory data.
Always back up the required data before switching.
3
Press [Execute].
4 Check the message, then press [Yes].
Setting the Number of Format
Converter Input/Outputs
1
In the Engineering Setup >System >Install/Unit
Config menu (7316), select “SWR1” and press [Unit
Config].
The Unit Config menu (7316.8) appears.
2
In the <FC Config> group, press one of the following.
8 in: 8 inputs (no outputs)
4 in 2 out: 4 inputs and 2 outputs
3
Press [Execute].
4
Check the message, then press [Yes].
System Maintenance
Setting the Date and Time
1 In the Engineering Setup >System >Maintenance
menu (7317), set the following parameters.
Parameter group [1/2]
Parameter group [2/2]
Using Removable Disks
Displaying removable disk information
1
Insert the removable disk to the DEVICE connector on
the control panel or menu panel.
2
In the <USB Storage Device> group of the
Engineering Setup >System >Maintenance menu
(7317), press [Refresh].
Formatting a removable disk
Notes
Format the removable disk if this is the first time the
removable disk has been used.
1
Insert the removable disk to the DEVICE connector on
the control panel or menu panel.
2
In the Engineering Setup >System >Maintenance
menu (7317), select the removable disk.
3
In the <USB Storage Device> group, press [Format].
4
Check the message, then press [Yes].
Carrying Out the Primary Setting
To specify a removable disk as a primary device, use the
following procedure.
Notes
Without this setting, you cannot use the “Removable Disk”
item in the File menu to access a removable disk. Be sure
to configure this setting.
1
In the Engineering Setup >System >Maintenance
menu (7317), select the removable disk.
2
In the <USB Storage Device> group, press [Set
Primary].
Making the primary setting automatic
In the <USB Storage Device> group, press [Auto Detect].
The set date and time appears in the “Set” column in
the status area.
2 Press [Set Date/Time].
To Next Page
Loading...
