Sony MVS-6520 - Selecting DSK5 to DSK8 in the Flexi Pad

USO RESTRITO
416
8-Keyer Operation
Appendix
DSK1 to DSK8: Corresponding key menu >XX (where
“XX” is the last recalled page)
WIPE: Corresponding key menu >Transition >Wipe
Adjust >Pattern Select
DME WIPE: Corresponding key menu >Transition
>DME Wipe Adjust >1ch Pattern Select
KSS STOR: Snapshot >Key Snapshot >XX (where “XX”
is the last recalled page)
Switching button
[DSK5] to [DSK8] is displayed in the VF buttons,
allowing you to select a key.
Selecting DSK5 to DSK8 in the Flexi
Pad
When the Flexi Pad is assigned to key operations, the
button display changes as shown in the following figure.
Example: Key adjust mode button display
Selecting DSK5 to DSK8 in the
Device Control Block
In an 8-keyer PGM/PST bank, you can select the
corresponding key (DSK1 to DSK8) when set to key wipe
positioner selection mode.
ALL/KEY SHIFT button Key selection buttons
SHIFT button K1/K5 to K4/K8 buttons
Press the [ALL/KEY SHIFT] region selection button.
When the button is pressed, the indicator on the key
selection buttons switches between [DSK1] to [DSK4] and
[DSK5] to [DSK8].
To insert/delete DSK5 to DSK8
Select the target key in key snapshot mode and press the
[KEY ON] button in the memory recall section.
To insert or delete using auto transitions, press the [AUTO
TRNS] button.
Selecting DSK5 to DSK8 using Menu
VF Buttons
In an 8-keyer PGM/PST bank, you change the indicator in
the menu VF buttons to select DSK1 to DSK8.
Press the [KEY5-8] menu title button, turning it on.
The operation buttons ([K1/K5] to [K4/K8]) in the device
control block can be used to select DSK5 to DSK8 by
holding down the [SHIFT] button.
For example, to select DSK5, press and hold the [SHIFT]
button and press the [K1/K5] button.
Selecting the Range of the Key Wipe
Position Adjustment
1 Open the Engineering Setup >Panel >Config
>Trackball User Setting menu (7321.31).
2 In the <Wipe Pos Key Select Module> group, select
one of the following.
KEY1-4: Sets key 1 to key 4.
KEY1-8: Sets key 1 to key 8.
Notes
If [KEY1-8] is selected, you can select multiple keys
and adjust the key wipe position.