Sony MVS-6520 - Creating and Saving a Master Timeline

USO RESTRITO
262
Creating and Saving a Master Timeline
Chapter
12
Keyframes
1 Press the [EFF] button, turning it on.
This switches the memory recall section to effect
operation mode.
2 Press the region selection button corresponding to the
region for which you want to save the register, turning
it on ( 1 p. 248).
3 Press the [EDIT ENBL] button, turning it on.
This switches the memory recall section to effect
editing mode.
4 Press the [STOR] button.
5 Enter the register number to save with the numeric
keypad buttons.
To search for an empty register, instead of entering a
number, press the [.] (period) button. To search for an
empty register common to all currently selectable
regions, press the [.] button again.
To search for an empty register in the 100 range, press
[1], [0], [0], [.] (period) in this order.
To search for an empty register in the 200 range, press
[2], [0], [0], [.] (period) in that order.
The entered register number or corresponding register
number appears in the alphanumeric display. If the
number is followed by a letter “e” or “E,” this indicates
the following.
e: Indicates the selected register is empty for the
regions selected in step 2.
E: Indicates that the corresponding register is empty in
all selectable regions.
6 Press the [ENTR] button.
This saves the effect in the specified register.
Creating and Saving a
Master Timeline
Creating and Saving a Master
Timeline in the Flexi Pad
Creating and saving a master timeline
You can save region information (information on any
regions, including the register numbers associated with the
regions) referred to as a master timeline in a dedicated
register. By recalling that register, you can manipulate the
regions and registers together.
Creating and saving a master timeline
1 Press the [EFF] button, turning it on.
This switches the memory recall section to effect
operation mode.
2 Recall the register number of the effect you want to
save on the master timeline for each region
( 1 p. 248) .
3 Press the buttons for the regions you want to save on
the master timeline, turning them on.
4 Press the region selection button [MSTR], turning it
on.
The display shows the number of the register last used
for master timeline register operation.
5 Press the [EDIT ENBL] button, turning it on.
This switches the memory recall section to effect
editing mode.
6 Press the [STOR] button.
7 With the numeric keypad buttons, enter the number of
the register in which you want to save the master
timeline.
To search for an empty register, instead of entering a
number, press the [.] (period) button.
The entered register number or corresponding register
number appears in the alphanumeric display. If the
number is followed by a letter “E,” the register is
empty.
8 Press the [ENTR] button.
The regions selected in step 3 and the register numbers
recalled in those regions are saved in the master
timeline register.
Notes
Saving the master timeline does not carry out a save of
effects. Save the effects for each region first, then carry out
the master timeline save.
Changing a master timeline
As an example, if you want to change the M/E-1 register
from Effect 11 to Effect 15, use the following procedure.
1 Recall the master timeline register you want to change
( 1 p. 249) .