Register Operations in the Menus 263
This simultaneously recalls M/E-1 register 11 and P/P
register 11, and the [M/E1] and [P/P] region selection
buttons light.
2
Press the region selection button [MSTR], turning it
off.
3
Turn on only the button for the region you want to
change (here, [M/E1]), and recall the desired register
(here, Effect 15).
This recalls M/E-1 register 15, while on P/P register 11
remains selected.
4
Press the buttons for the regions you want to save on
the master timeline (here, [M/E1] and [P/P]), turning
them on.
5
Press the region selection button [MSTR], turning it
on.
The alphanumeric display shows the register number
last used for master timeline operation.
6
Press the [EDIT ENBL] button, turning it on.
This switches the memory recall section to effect
editing mode.
7
Press the [STOR] button.
8
With the numeric keypad buttons, enter the number of
the register in which you want to save the master
timeline, and press the [ENTR] button.
This saves M/E-1 register 15 and P/P register 11 in the
master timeline register.
Creating and Saving a Master
Timeline with the Menu
1
Open the Effect >Master Timeline >Store menu
(6211).
The status area shows the master timeline register
names, register lock status, register number for each
region, and so on.
2
If necessary, press one of the following buttons in the
status area to change the region display.
M/E, P/P: Indicates assignment of M/E-1 (ME1), P/P
(P/P).
User: Shows the allocations for User1 (USR1) to
User8 (USR8).
DME: Indicates assignment of DME ch1 (DME1),
ch2 (DME2), ch5 (DME5), ch6 (DME6), ch7
(DME7), and ch8 (DME8).
DEV1-8: Indicates assignments for Device1 (DEV1)
to Device8 (DEV8).
DEV9-12: indicates assignments for Device9 (DEV9)
to Device12 (DEV12).
Misc: Indicates assignment for P-Bus (PBUS), GPI
(GPI), and Macro (MCRO).
3
Select the register in which you want to save the
master timeline.
4
Press [Edit].
The Edit menu (6211.1) appears.
You can also use the [Master Reg] parameter to select
the master timeline register in this menu.
The status area shows the status of each region in this
master timeline.
5
Select a region.
You can select more than one region.
To select all regions, press [ALL]. To select all
switcher-related regions (M/E, P/P, User), press [SWR
ALL].
6
Press [Assign], turning it on.
If the selected register is locked, a confirmation
message appears asking whether or not to cancel the
operation. Press [OK] to return to the previous menu
display without carrying out the registration.
If the operation is carried out, the region selected in
step 5 is registered on the master timeline, and the
parameters are now valid.
7
Select the number of the effect register.
8
Repeat steps 5 to 7 as required to set all regions and
register numbers to be saved on the master timeline.
9
In the <Store> group, press [Store].
To return to the state before saving the master
timeline content
In the <Store> group, press [Undo].
Register Operations in
the Menus
Using the Effect menu, you can carry out the following
effect register operations.
To Next Page
Loading...
