Sony MVS-6520 - Page 222

USO RESTRITO
222
Global Effect Operations
No.
Parameter
Adjustment
1
Mix2
Mix degree for channels 7 and
8
a)
No.
Parameter
Adjustment
1
Mix
Mix degree
a)
No.
Parameter
Adjustment
1
Mix1
Mix degree for mix of channel 5
with result of Mix2
a)
2
Mix2
Mix degree for channels 6 and
7
a)
No.
Parameter
Adjustment
1
Mix1
Mix degree for channels 5 and
6
a)
Chapter
10
DME
Operations
The selected channels are combined.
To cancel a combine
When for example [Ch6+Ch7] is on, pressing [Ch6+Ch7]
once more turns it off. Alternatively, pressing a different
combination button to select it cancels the combine
selection for the current combination.
Mixing the images of up to four
consecutive channels
1 In the Global Effect >Ch5-Ch8 >Combiner Priority
menu (4221), press [Mix], turning it on.
2 Adjust the following parameters.
For “Ch5+Ch6”
a) 1 p. 220.
For “Ch5+Ch6+Ch7”
a) 1 p. 220.
For “Ch5+Ch6+Ch7+Ch8”
The [Mix1] and [Mix2] parameters set the same
parameters as for “Ch5+Ch6+Ch7” respectively. The
[Mix3] parameter can also be set.
Mixing pairwise the images of channels 5
and 6, and channels 7 and 8
1 In the Global Effect >Ch5-Ch8 >Combiner Priority
menu (4221), press [Combiner1 Mix], turning it on.
2 Adjust the following parameter.
a) 1 p. 221.
3 Press [Combiner2 Mix], turning it on.
4 Adjust the following parameter.
a) 1 p. 221.
Automatically setting the priority of
overlapping images
To set the system so that the priority of overlapping images
is automatically determined by their position on the Z-axis,
in the Global Effect >Ch5-Ch8 >Combiner Priority menu
(4221), press [Auto], turning it on.
Notes
It is not possible to cross images. If an image is rotated, the
priority is determined by the position on the Z-axis of the
center of the image.
Crossing images from up to four
consecutive channels in three dimensions
Notes
Three-dimensional image crossing is not supported on the
MKS-6570 or MVE-8000A.
1 In the Global Effect >Ch5-Ch8 >Combiner Priority
menu (4221), press [Depth], turning it on.
2 Adjust the following parameters.
For “Ch5+Ch6”
No.
Parameter
Adjustment
1
Soft
Softness of edges of crossed
section
For “Ch5+Ch6+Ch7”
No.
Parameter
Adjustment
1
Soft1
Softness of edges of channel 5
and channel 6 crossed section
2
Soft2
Softness of edges of channel 6
and channel 7 crossed section
For “Ch5+Ch6+Ch7+Ch8”
The [Soft1] and [Soft2] parameters set the same
parameters as for “Ch5+Ch6+Ch7” respectively. The
[Soft3] parameter can also be set.