Prepare failed, insufficient Clip id (–
15).
2565: Frame Memory >External Device >Restore from DDR/VTR
When [Restore Start] was pressed, there were insufficient Clip IDs (internal
processing error).
Restore failed, Cannot find symbol
files on this tape (–18).
2565: Frame Memory >External Device >Restore from DDR/VTR
When [Restore Start] was pressed, a marker frame file could not be found.
ERROR (–19). Bad register number.
2565: Frame Memory >External Device >Restore from DDR/VTR
When [Restore Start] was pressed, the Register Number was an invalid
value (internal processing error).
Restore failed, file name already exist,
try to rename but unsuccessful (–20).
2565: Frame Memory >External Device >Restore from DDR/VTR
When [Restore Start] was pressed, renaming failed.
Cannot find the File Name Data,
please load the File Name Data first
(–21).
2565: Frame Memory >External Device >Restore from DDR/VTR
When [Restore Start] was pressed, the file list was not loaded.
Set Time/Date
7317: Engineering Setup >System >Maintenance
A correct date and time was not specified. Specify the correct date and time.
Trim
The Start TC or Stop TC is not
properly set.
2522: Frame Memory >Clip >Play
When [Trim] was pressed, neither the Start TC nor the Stop TC was set.
2522: Frame Memory >Clip >Play
When [Trim] was pressed, the interval between Start TC (or Clip Begin) and
Stop TC (or Clip End) was the entire clip.
2522: Frame Memory >Clip >Play
When [Trim] was pressed, the Start TC (or Clip Begin) value was greater
than the Stop TC (or Clip End) value.
2522: Frame Memory >Clip >Play
When [Trim] was pressed, the file was locked.
This file is using for playback.
2522: Frame Memory >Clip >Play
When [Trim] was pressed, the target file was being played back.
Warning
This operation will be cancelled,
because the register is locked.
Please change the register status to
be unlocked first.
6211.1: Effect >Master Timeline >Store >Edit
6311.1: Snapshot >Master Snapshot >Store >Edit
6411.1: Shotbox >Register >Store >Edit
When [Store] was pressed, the target register was locked. Unlock the
register before executing [Store].
Error Messages Shown in the Error Information Menu
If a file transfer related error occurs, the Error Information
menu appears to the following error messages.
Error description/measures
[Error] Server Not Respond
There is absolutely no response on the LAN from the processor.
Check your LAN connections and the power source of the processor.
There is insufficient space in the local disk or removable disk.
If a message other than those above appears, store the data
or recall the data again. If the error message persists,
contact your Sony service representative.
To Next Page
Loading...
