Sony SLV-400 - Page 46

GeneralSetupInformation
1
2
3
Loosen the screws on the antenna connector.
Fit the 300-ohm twin lead cable on the UHF antenna
under the screws on the antenna connector,
Retighten the screws.
1
2
3
4
5
Loosen the screws on the U/V band separator/mixer.
Fit the 300-ohm twin lead cable on the UHF antenna
under the screws.
Retighten the screws.
Connect the 75-ohm coaxial cable to the U/V band
separator/mixer.
Connect the U/V band separator/mixer to the
VHF/UHF IN plug on the VCR.
6 Additional Information