HookupsandGettingStarted
Before you can use your VCR for.the first time, you.need to
connect it to your TV andset it up to receive programs for
-. viewing and recording. This sec_tionexplains how to hook up,
set up, and operate your VCR so that you can start enjoying
it rightaway. There are, however, many types of TVs
available and many different ways in which your TV can be
hooked up. As a result, this manual describes several ways
your VCR can be connected.
1o hook up your VCR so that it works best for you, first scan
through this section to find the diagram that best illustrates
the way your TV Jscurrently connected (antenna or
cable/cable box). Then use the accompanying diagrams and
procedures to complete your VCR's connections.
After you've completed the connections, follow the
instructions for setup. (Dudng setup, if you need more details
of the procedures described, page numbers are provided
where you Can find complete, step-by-step instructions.)
After you've completed the setup, you're ready to use your
VCR. Follow the instructions provided in "To Watch the TV,"
"To Watchthe VCR," and "To Record A Program" for your
specific hookup.
qlAgain, if you need step-by-step instructions, page numbers
are provided where you can find this information.)
Befo_:emaking the connections, check the following points:.
• Turn off the power to the VCR and TV.
• Do not connect the AC power cord until all of the
connections are completed.
• Make connections firmly. Loose connections may cause
picture distortion.
• If your TV doesn't match any of the examples provided,
• consult your nearest Sony dealer or qualified technician.
Caution
Connections between the VCR VHF/UHF OUT
connector and the antenna terminals of a TV receiver
should be made only as slnowninthe instructions.
Failure to do so may result in operation that violates the
regulations of the Federal Communications
Commission regarding the use and operation of RF
devices. Never connect the output of the recorder to an
antenna or make simultaneous (parallel) antenna and
recorder connections at the antenna terminals of your
receiver.
41=P
Preparation
To Next Page
Loading...
