SNC-EP520/EP521/EP550/EP580/ER520/ER521/ER550/ER580/ER585/ER585H/ZP550/ZR550
Administrating the Camera
Configuring the Network — Network Menu
43
Note
Specify different numbers for the video port number and
the audio port number.
OK/Cancel
See “Buttons common to every menu” on page 26.
Configuring the Network
— Network Menu
When you click in the Administrator menu, the
Network menu appears.
Use this menu to configure the network to connect the
camera and the computer.
The Network menu consists of three tabs: Network,
QoS and Dynamic IP address notification.
Network Tab
This section provides the menus for connecting the
camera through the network cable.
MAC address
Displays the MAC address of the camera.
Ethernet status
Displays the current transmission rate.
This is displayed when the network change selection
switch is set to LAN. This is not displayed when it is set
to SLOC (SNC-ZP550/ZR550).
Auto-MDI/MDIX
Automatically distinguishes the port of the Ethernet
device connected to the unit and switches the port of the
unit between MDI and MDI-X for transmission.
Displays the Ethernet port mode of the unit.
This is displayed when the network change selection
switch is set to LAN. This is not displayed when it is set
to SLOC (SNC-ZP550/ZR550).
Network type (SNC-ZP550/ZR550)
Displays the network type.
Network
To Next Page
Loading...
