W Center speaker size (CENTER)
Multi channel surround setup
(continued)
Initial settings
Parameter
Initial settina
FRONT
LARGE
CENTER
LARGE
SURROUND LARGE
SURR BACK LARGE
SURR BACK L/R NO
SUB WOOFER
YES
FRONT XX.X feet 16 feet
CENTER Xx.X feet
16
feet
SURROUND XX.X feet
SURR BACK Xx.X feet
11 feet
11 feet
SUB WOOFER Xx.X feet 16 feet
S.W PHASE NORMAL
DISTANCE UNIT FEET
SURR POSI. SIDE
SURR HEIGHT
SURR BACK HGT.
FRONT SP > XXX Hz
LOW
LOW
STD (120 Hz)
CENTER SP > XXX Hz STD f 120 Hz)
SURROUND SP > XXX Hz
SURR BACK SP > XXX Hz
LPB HIGH CUT > XXX Hz
STD (120 Hz)
STD (120 Hz)
STD (120 Hz)
n Front speaker size (FRONT)
l
If you connect large speakers that will
effectively reproduce bass frequencies, select
“LARGE”. Normally, select “LARGE”.
l
If the sound is distorted, or you feel a lack of
surround effects when using multi channel
surround sound, select “SMALL” to activate
the bass redirection circuitry and output the
front channel bass frequencies from the sub
woofer.
l
When the front speakers are set to “SMALL”,
the center, surround, and surround back
speakers are also automatically set to
“SMALL” (unless previously set to “NO”).
If you connect a large speaker that will
effectively reproduce bass frequencies, select
“LARGE”. Normally, select “LARGE”.
However, if the front speakers are set to
“SMALL”, you cannot set the center speaker to
“LARGE”.
If the sound is distorted, or you feel a lack of
surround effects when using multi channel
surround sound, select “SMALL” to activate
the bass redirection circuitry and output the
center channel
bass
frequencies from the front
speakers (if set to “LARGE”) or sub woofer.*’
If you do not connect a center speaker, select
“NO”. The sound of the center channel will be
output from the front speakers.**
If you use the center speaker in the 2nd room,
select “2ND ROOM”. When the center speaker
is set to “2ND ROOM’, the surround back
speaker is also automatically set to “2ND
ROOM” (unless previously set to “NO”).
W Surround speaker size (SURROUND)
If you connect large speakers that will
effectively reproduce bass frequencies, select
“LARGE”. Normally, select “LARGE”.
However, if the front speakers are set to
“SMALL”, you cannot set the surround
speakers to “LARGE”.
If the sound is distorted, or you feel a lack of
surround effects when using multi channel
surround sound, select “SMALL” to activate
the bass redirection circuitry and output the
surround channel bass frequencies from the sub
woofer or other “LARGE?’ speakers.
If you do not connect surround speakers, select
‘~No”,M
TiP
*l-*3 correspond to the following Dolby Pro Logic
modes
*l NORMAL
*2 PHANTOM
*3 3 STEREO
18
To Next Page
Loading...
