43
GB
Additional Information
No sound or only a very low-level sound is heard
from the surround speakers.
, Make sur e the sound field function is on (pr ess
SOUND FIELD MODE).
, Select the appr opriate center mode (see pages
25–27).
, Adjust the speaker volume (see page 18).
, Make sur e the sur round speaker size parameter is
set to either SMALL or LARGE (see page 16).
No sound is heard from the sub woofer.
, Make sur e the sub woofer is set to YES (see page
17).
, Check that 2CH mode has not been selected (see
page 27).
Recording cannot be done.
, Check that the components ar e connected cor rectly .
, Select the sour ce component with a FUNCTION
button.
, When r ecor ding fr om a digital component, make
sure the input mode is set to ANALOG (see page
23) befor e r ecor ding with a component connected
to the analog MD/T APE ter minals.
Radio stations cannot be tuned in.
, Check that the antennas ar e connected secur ely .
Adjust the antennas and connect an external
antenna if necessar y.
, The signal str ength of the stations is too weak
(when tuning in with automatic tuning). Use dir ect
tuning.
, Make sur e you set the tuning inter val cor rectly
(when tuning in AM stations with dir ect tuning)
(see pages 36 and 45).
, No stations have been pr eset or the pr eset stations
have been clear ed (when tuning by scanning pr eset
stations). Pr eset the stations (see page 37).
, Press DISPLA Y so that the fr equency appears in
the display .
The surround effect cannot be obtained.
, Make sur e the sound field function is on (pr ess
SOUND FIELD MODE).
“PCM--kHz” appears on the display.
, The sampling fr equency is mor e than 48 kHz.
Change the input player setting to 48 kHz.
Nothing appears on the display.
, When the display tur ns of f immediately after the
receiver is tur ned on, pr ess DIMMER to change the
display mode.
No picture or an unclear picture appears on the
TV screen or monitor.
, Select the appr opriate function on the r eceiver .
, Set your TV to the appr opriate input mode.
, Move your TV away fr om the audio components.
The remote does not function.
, Point the r emote at the r emote sensor g on the
receiver .
, Remove any obstacles in the path between the
remote and the r eceiver .
, Replace both batteries in the r emote with new
ones, if they ar e weak.
, Make sur e you select the cor rect function on the
remote.
, If the r emote is set to operate the TV only , use the
remote to select a sour ce or component other than
TV befor e operating the r eceiver or other
component.
Reference sections for clearing the
receiver’s memory
To clear See
All memorized settings page 14
Customized sound fields page 32
To Next Page
Loading...
