36
GB
Receiving Broadcasts
bb
35
1
b
0
Direct Tuning
For details on the buttons used in this section, see “Brief
descriptions of buttons used to r eceive br oadcasts” on
page 35.
1 Press TUNER.
The last r eceived station is tuned in.
2 Press FM or AM to select the FM or AM band.
3 Press D.TUNING on the remote.
4 Press the numeric buttons on the remote to enter
the frequency.
Example 1: FM 102.50 MHz
Example 2: AM 1350 kHz
(You don’t have to enter the last “0” when the tuning interval
is set to 10 kHz)
If you cannot tune in a station and the
entered numbers flash
Make sur e you’ve enter ed the right fr equency . If not,
repeat Steps 3 and 4.
If the enter ed numbers still flash, the fr equency is not
used in your ar ea.
5 If you’ve tuned in an AM station, adjust the
direction of the AM loop antenna for optimum
reception.
6 Repeat Steps 2 to 5 to receive other stations.
z
If you try to enter a frequency not covered by the tuning
interval
The entered value is automatically rounded up or down.
This tuning scale for direct tuning differs depending on the area
code as shown in the following table. For details on area codes,
see page 3.
Area code FM tuning scale AM tuning scale
U, CA 50 kHz 10 kHz (can be changed
to 9 kHz)*
E2, E3, TW 50 kHz 9 kHz (can be changed
to 10 kHz)*
AU, CN 50 kHz 9 kHz
* To change the AM tuning scale, see page 45.
Automatic Tuning
For details on the buttons used in this section, see “Brief
descriptions of buttons used to r eceive br oadcasts” on
page 35.
1 Press TUNER.
The last r eceived station is tuned in.
2 Press FM or AM to select the FM or AM band.
3 Press TUNING + or TUNING –.
Press the + button to scan fr om low to high; pr ess the –
button to scan fr om high to low .
When the receiver reaches either end of the
band
Scanning is r epeated in the same dir ection.
The r eceiver stops scanning whenever a station is
received.
4 To continue scanning, press TUNING + or TUNING –
again.
bbbb
025
0
1
To Next Page
Loading...
