Troubleshooting
If you experience any of the following
difficulties while using the receiver, use this
troubleshooting guide to help you remedy the
problem.
Audio
There is no sound, no matter which
component is selected, or only a very
low-level sound is heard.
• Check that the speakers and components
are connected securely.
• Check that all speakers cords are
connected correctly.
• Check that both the receiver and all
components are turned on.
• Check that MASTER VOLUME is not set
to "VOLUME MIN".
• Check that the SPEAKERS (OFF/A/B/
A+B) is not set to "OFF".
• Check that headphones are not connected.
• Press MUTING to cancel the muting
flmction.
• Check that you have selected the correct
component with the input buttons.
• The protective device on the receiver has
been activated. Turn off the receiver.
eliminate the short-circuit problem, and
turn on the power again.
There is no sound from a specific
component.
• Check that tile component is conuected
correctly to the audio input jacks for that
component.
• Check that the cord(s) used for the
connection is (are) filly inserted into the
jacks on both the receiver and the
component.
There is no sound from one of the front
speakers.
• Connect a pair of headphones to the
PHONES jack to verify that sound is
output from the headphones. If only one
channel is output from the headphones, the
component may not be connected to the
receiver correctly. Check that all the cords
are fully inserted into the jacks on both the
receiver and the component. If both
channels are output from the headphones,
the front speaker may not be connected to
the receiver correctly. Check the
connection of the front speaker which is
not outputting any sound.
• Make sure you have connected to both the
L and R jacks of an analog component, and
not only to either the L or R jack. Use an
audio cord (not supplied).
There is no sound from analog 2
channel sources.
• Check that the INPUT MODE is not set to
"COAX IN", "OPT IN" or "HDMI IN" I_r
the selected input (page 71).
There is no sound from digital sources
(from COAXIAL or OPTICAL input jack).
• Check that the INPUT MODE is not set to
D..
"ANALOG" or "HDMI IN" (page 71).
• Check that the ANALOG DIRECT
function is not selected.
• Check that the DIGITAL ASSIGN
function is not used to reassign the audio
input of another source to be selected input
(page 75).
8"
continued_
87Us
To Next Page
Loading...
