Specifications
AUDIO POWER
SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
(Models of area code U only)
With 8 ohm loads, both channels driven, fronl
20 20,000 Hz; rated 100 watts per channel
minimum RMS power, with no more than
0.09% total harmonic distortion from 250
milliwatts to rated output.
Amplifier section
Models of area code U, CA 1)
Minimum RMS Output Power (8 ohms. 20 Hz
21) kHz, THD 0.09(7, )
100 W + 100 W
Stereo Mode Output Power (8 ohms. I kHz,
THD 1%)
ll0W+ ll0W
%
Surround Mode Output Power- (8 ohms. 1 kHz,
THD 10%)
150 W/oh
l)Measured under the following conditions:
Area code Power requirements
U. CA 120 V AC. 60 Hz
2)Reference power outpul for frout, ceuter, surruund
and surround back spe&ers. Depending on the
sound field settings and the source, there may be
no suund uutput.
Frequency response
Analog 10 Hz - 70 kHz,
+0.5/ 2 dB (with sound
field and equalizer
bypassed)
Input
Analog
Digital (Coaxial)
Digital (Optical)
Output (analog)
AUDIO OUT
SUB WOOFER
Equalizer
Gain levels
Sensitivity: 500 mV/
50 kohms
S/N3): 96 dB
(A, 500 lnV 4))
Impedance: 75 ohms
SIN: 100 dB
(A, 20 kHz LPF)
SIN: 100 dB
(A, 20 kHz LPF)
Voltage: 500 mY/10 kohms
Voltage: 2 V/I kohm
_+10 dB. 1 dB step
3IlNPUT SHORT (with sound field and equalizer
bypassed).
4)Weighled nelwork, input ]eveh
FM tuner section
Tuning range 87.5 - 108.0 MHz
Antenna FM wire antenna
Antenna terminals 75 ohms. unbalanced
Intermediate fi÷equency
I1).7MHz
AM tuner section
Tuning range
Area Tuning scale
_>
code 10 kHz step 9 kHz step O..
U, CA 530 1,710kHz 5) 531 1,710kHz 5)
-,z
Ailtenna Loop antenna
Intermediate frequency 5"
450 kHz _'
5)Yuu can change tile ANt tuning scale tu 9 kHz or _"
IOkHz. After tuning ill any AM station, turn off "_
the receiver. While hulding down TUNING
MODE, press I/(_. All preset stations will be
erased when you change the tuning scale. To reset
the scale to 10kHz/or 9 kHz), repeat the
procedure.
continued_
91us
To Next Page
Loading...
