Video Tuner
There is no picture or an unclear
picture appears on the TV screen or
monitor.
• Select the appropriate input using the input
buttons.
• Set your TV to the appropriate input mode.
• Move your audio components away from
the TV.
• Assign the composite video input to
DMPORT input correctly.
• Depending on the DIGITAL MEDIA
PORT adaptor, video outpnt may not be
possible.
The source image input to the HDMI
jack on the receiver is not output from
the TV.
• Check the HDMI connectiou.
• Depending on the playback component,
yon may need to set up the component.
Refer to the operating instructions
supplied with each component.
Recording cannot be carried out.
• Check that tile compoueuts are connected
correctly.
• Select the source component using the
input buttons.
The FM reception is poor.
• Use a 75-ohm coaxial cable (not supplied)
to connect the receiver to an outdoor FM
antenna as shown below. If you connect
the receiver to an outdoor antenna, ground
it against lightning. To prevent a gas
explosion, do not connect the ground wire
to a gas pipe.
Outdoor FM antenna
Receiver
To ground
Ground wire
(not supplied)
Radio stations cannot be tuned in.
• Check that the antennas are connected
securely. Adjust the antennas and connect
an external antenna, if necessary.
• The signal strength of the stations is too
weak (when tuning in with automatic
tuning). Use direct tuning.
• Make sure you set the tuning interval
correctly (when tuning in AM stations
with direct tuning). _"
• No stations have been preset or the preset
stations hax.e been cleared (when tuning by 5"
scanning preset stations). Preset the _'
stations (page 60).
• Press DISPLAY repeatedly on the receiver -_.
so that the frequency appears on the "_
display.
continued,
89us
To Next Page
Loading...
