Note
This function does not work in the following cases:
[DIRECT] is selected and an analog input is selected.
Headphones are connected.
The receiver may play signals at a lower sampling frequency than the actual sampling frequency of
the input signals, depending on the audio format.
[96] Adjusting Settings Level Settings
Outputting a test tone from each speaker (TEST TONE)
You can output a test tone from each speaker in sequence.
This operation is only available using the display panel on the front of the receiver.
Hint
To adjust the level of all speakers at the same time, press +/–. You can also use MASTER
VOLUME on the receiver.
The adjusted value is shown on the display panel during adjustment.
Select [<AUTO CAL>] - [CAL TYPE] on the display panel.
2
Select the setting you want.
FULL FLAT: Makes the measurement of frequency from each speaker flat.
ENGINEER: Sets to “the Sony listening room standard” frequency characteristics.
FRONT REF: Adjusts the characteristics of all of the speakers to match the
characteristics of the front speaker.
OFF
3
Press AMP MENU.
1
Select [<LEVEL>] - [TEST TONE] on the display panel.
2
Select the setting you want.
OFF
AUTO XXX (*): The test tone is output from each speaker in sequence.
3
XXX represents a speaker channel (FL, CNT, FR, SR, SBR, SB, SBL, SL, LH, RH, SW)
*
Select the speaker on the screen for which you want to adjust the speaker level.
4
Adjust the speaker level.
5
To Next Page
Loading...
