Switching between digital and analog audio (INPUT MODE) [80]
Using other audio input jacks (A. ASSIGN) [81]
Using the sleep timer
Using the sleep timer [82]
Checking information on the receiver
Viewing information on the display panel [83]
Adjusting Settings
Using the menu on the display panel
Operating the receiver with the menu on the display panel [84]
Viewing information on the display panel [85]
Easy Setup
Setting up the receiver using Easy Setup [86]
Selecting the language [87]
Assigning the surround back speaker terminals (Surround Back Speakers Assign)
[88]
Performing Auto Calibration
1. About Auto Calibration [89]
2. Before you perform Auto Calibration [90]
3. Connecting the calibration microphone [91]
4. Selecting the front speakers [92]
5. Performing Auto Calibration [93]
6. Checking Auto Calibration results [94]
Selecting the Auto Calibration type (CAL TYPE) [95]
Level Settings
Outputting a test tone from each speaker (TEST TONE) [96]
Adjusting the speaker level (Level) [97]
Speaker Settings
Selecting the speaker pattern (SP PATTERN) [98]
Assigning the surround back speaker terminals (Surround Back Speakers Assign)
[99]
Adjusting the speaker size (Size) [100]
Adjusting the speaker distance (Distance) [101]
Setting the crossover frequency of the speakers (Crossover Freq) [102]
Selecting the unit of measurement (DIST. UNIT) [103]
Input Settings
Switching between digital and analog audio (INPUT MODE) [104]
To Next Page
Loading...
