Sony STR-DH770 - Page 74

Note
[Crossover Freq] cannot be set when headphones are connected.
[Crossover Freq] for the particular speaker cannot be set if [Size] is set to [Large] in the [Speaker
Setting] menu.
The surround back speakers will be set to the same setting as that of the surround speakers.
Hint
You can also set the crossover frequency of speakers from the [<SPEAKER>] menu on the display
panel.
[103] Adjusting Settings Speaker Settings
Selecting the unit of measurement (DIST. UNIT)
You can select the unit of measurement for setting distances.
This operation is only available using the display panel on the front of the receiver.
[104] Adjusting Settings
Input Settings
Switching between digital and analog audio (INPUT
MODE)
When you connect devices to both digital and analog audio input jacks on the receiver, you can
fix the audio input mode to either device, or switch from one to the other, depending on the type
of material you intend to watch.
This operation is only available using the display panel on the front of the receiver.
frequency.
Set the crossover frequency.
4
Press AMP MENU.
1
Select [<SPEAKER>] - [DIST. UNIT] on the display panel.
2
Select the setting you want.
METER: The distance is displayed in meters.
FEET: The distance is displayed in feet.
3
Press the input buttons to select the input.
1
Press AMP MENU.
2
Select [<INPUT>] - [INPUT MODE] on the display panel.
3