1. Select [Setup] - [Network Settings] from the home menu.
2. Select [Auto Renderer Access Permission].
3. Select the setting you want.
On
Off
[190] Adjusting Settings Network Settings
Setting whether to control this receiver from a controller
device on the home network (Renderer Access Control)
You can check a list of products compatible with a controller on the home network and set
whether or not each product is accessible via this receiver.
1. Select [Setup] - [Network Settings] from the home menu.
2. Select [Renderer Access Control].
A list of registered controllers appears (up to 40 devices).
3. Select the controller you want to set and press .
4. Select the setting you want.
Allow: Permits access from the controller.
Block: Blocks access from the controller.
[191] Adjusting Settings Network Settings
Checking the registered TV SideView device (Registered
Remote Devices)
You can check the TV SideView devices which are able to control the receiver.
1. Select [Setup] - [Network Settings] from the home menu.
To Next Page
Loading...
