2. Select [Registered Remote Devices].
Note
You can register up to 5 TV SideView devices. If you want to add a new device when a
maximum of 5 devices are set, remove unnecessary devices before adding the new
device.
[192] Adjusting Settings
Network Settings
Enabling the network function even when this receiver is
in standby mode (Remote Start)
1. Select [Setup] - [Network Settings] from the home menu.
2. Select [Remote Start].
3. Set to [On] or [Off].
On: Allows the receiver to be turned on by a device via the network when the
receiver is in standby mode.
Off: The receiver cannot be turned on by a device via the network.
[193] Adjusting Settings Network Settings
Turning on the control mode for maintenance (External
Control)
You can set whether a dedicated controller (home automation controller) on the home
network is allowed to control the receiver.
1. Select [Setup] - [Network Settings] from the home menu.
2. Select [External Control].
3. Set to [On] or [Off].
To Next Page
Loading...
