Sony STR-DN860 - Page 183

2. Select [Zone2 Volume] or [Zone3 Volume].
3. Select the volume level.
Note
If [Zone2 Line Out] is set to [Fixed], adjust the volume using the receiver in Zone 2.
Hint
You can also adjust the volume using ZONE SELECT and MASTER VOLUME on the
receiver while [2. xxxx (input name)] or [3. xxxx (input name)] is shown on the display
panel.
[202] Adjusting Settings
Zone Settings (for STR-DN1060 only)
Setting the volume control for Zone 2 (Zone2 Line Out)
(for STR-DN1060 only)
You can set variable or fixed volume control for the ZONE 2 AUDIO OUT jacks.
1. Select [Setup] - [Zone Settings] from the home menu.
2. Select [Zone2 Line Out].
3. Select the setting you want.
Variable:
Recommended when using another amplifier that does not have volume control for
Zone 2.
The volume for the ZONE 2 AUDIO OUT jacks can be changed.
Fixed:
Recommended when using another amplifier with variable volume control for Zone
2. The volume for the ZONE 2 AUDIO OUT jacks is fixed.
Note
When [Variable] is set, the volume is turned down by default. Turn up the volume while
listening to the sound after completing setup. The volume for the SPEAKERS
SURROUND BACK/BI-AMP/FRONT HIGH/FRONT B/ZONE 2 terminals is changed
together with the volume for the ZONE 2 AUDIO OUT jacks.