Sony STR-DN860 - Page 182

Hint
You can also turn the power for Zone 2/Zone 3/HDMI zone on or off using ZONE POWER
on the receiver.
[200] Adjusting Settings
Zone Settings (for STR-DN1060 only)
Selecting source signals for Zone 2/Zone 3/HDMI zone
(Input) (for STR-DN1060 only)
You can select the source signals for Zone 2/Zone 3/HDMI zone by following the steps
below.
1. Select [Setup] - [Zone Settings] from the home menu.
2. Select [Zone2 Input], [Zone3 Input] or [HDMI Zone Input].
3. Select the source signals you want to output.
Hint
You can also select the source signals for Zone 2/Zone 3/HDMI zone using ZONE
SELECT and INPUT SELECTOR on the receiver while [2. xxxx (input name)], [3. xxxx
(input name)] or [H. xxxx (input name)] is shown on the display panel.
[201] Adjusting Settings
Zone Settings (for STR-DN1060 only)
Adjusting the volume for Zone 2/Zone 3 (Volume) (for
STR-DN1060 only)
You can adjust the volume for Zone 2 or Zone 3 by following the steps below in the following
cases:
When using the connections described in “1. Connecting the speakers in Zone 2 and/or
Zone 3 (for STR-DN1060 only)”
When using the connections described in “1. Connecting another amplifier in Zone 2 (for
STR-DN1060 only),” and when [Zone2 Line Out] is set to [Variable].
1. Select [Setup] - [Zone Settings] from the home menu.