11
Location and Function of Parts
Chapter 1 Overview
Location and Function of Parts
Front Panel of Monitor
a Tally lamp
With factory settings, the tally lamp lights when pins No. 8
and No. 9 of the PARALLEL REMOTE connector on the
rear panel are shorted. By changing the setting in the
PARALLEL REMOTE menu, different pins on the
PARALLEL REMOTE connector can be used to control
the tally lamp.
For information about the PARALLEL REMOTE menu,
see “
[D]
System Configuration – SYSTEM
CONFIGURATION Menu” on page 42.
b OPERATE lamp
Lights when the monitor is put into operation mode from
standby mode (see 3 STANDBY lamp) by pressing the
MONITOR I/1 switch of the BKM-15R.
When the STANDBY lamp is blinking, the monitor cannot
be put into operation mode (internal data initialization is
taking place). Wait until the STANDBY lamp is steadily
lit.
c STANDBY lamp
Lights when the monitor is in standby mode. The monitor
will be in standby mode under the following conditions:
• The MAIN POWER switch (on the rear panel) is turned
on (the STANDBY lamp will blink for a few moments
after the switch is turned on, then will light).
• The monitor is changed from operation mode to standby
mode by external control.
d OVER LOAD lamp
Lights to warn of CRT overload.
When the OVER LOAD lamp is lit, use the unit with the
contrast or brightness reduced.
e OPTION connector
Used to connect the auto setup probe (BKM-14L, etc).
1 Tally lamp
2 OPERATE lamp
3 STANDBY lamp
4 OVER LOAD lamp
5 OPTION connector
Note
To Next Page
Loading...
