86
Setting Up the Printer (Continued)
Connection and Adjustment
75 ohm
Selects whether the printer is terminated with 75-ohm impedance.
ON: When no equipment is connected to the VIDEO OUT connector of the printer.
OFF: When equipment such as a monitor or a VTR is connected to the VIDEO
OUT connector of the printer.
When you connect two printers to one video equipment, set the 75 ohm sub menu
of one of the printer to ON, and the other to OFF.
CLEAR
Clears all the images stored in memory in the multi picture mode.
To clear the images, press the EXEC button.
Display the CLEAR sub menu easily
Press the CLEAR button on the sub panel. (See page 69.)
AUTO CUT
Sets the printer to the auto cut mode. The paper is automatically cut when printing
is completed.
ON: Sets the printer to auto cut mode.
OFF: The paper should be cut manually by using the CUT button. Using this
mode, you can save paper and make more printouts per roll of paper.
CLEAR
<
EXEC
>
AUTO CUT
ON / OFF
75ohm
ON / OFF
To Next Page
Loading...
