Sony UP-D897 - 1-3-2. Front Panel Subassembly; 1-3-3. Rear Panel

1-3-2. Front Panel Subassembly 1-3-3. Rear Panel
1. Remove the top cover: (Refer to Section 1-3-1.) 1. Remove the top cover. (Refer to Section 1-3-1.)
2. Release the lock arm of the mechanical deck block 2. Remove the two screws (PS3 X 6) and the screw (B3 X
(bottom surface) in the direction of the arrow, then 6), then remove the rear panel.
open the door panel.
3. Remove the four hooks in both directions of the
arrows, then remove the door panel in the direction of
the arrow.
4. Disconnect the flexible flat cable from the connector
(CN201) on the MA-132 board.
Rear panel
3. Attach the rear panel in the reverse order of steps 1
and 2.
Door panel
5. Remove the two screws and five hooks, then remove
the front panel subassembly.
Front panel subassembly
6. Attach the front panel subassembly in the reverse order
of steps 1 to 5.
-2 UP-D897