58
nN
Using your VAIO computer
To activate Standby mode, proceed as follows:
Go to Start/Turn Off Computer and press Stand By.
Or press the <Fn>+<Esc> keys simultaneously.
To return to Normal mode, press any key.
ā If you press the power button for more than 4 seconds, the computer will switch off automatically. You will lose any unsaved data.
When the computer is in Standby mode, you cannot insert a disc.
The computer comes out of Standby mode quicker than out of Hibernate mode.
Standby uses more power than Hibernate.
If the battery runs down when your computer enters Standby mode, you will lose any unsaved data. Going back to the previous work state is impossible. To avoid loss of
data, you should save your data frequently.
If the computer is not used for 25 minutes, it will enter Standby mode. To avoid this, you can change the settings in the Power
Options Properties screen (right-click the power status icon in the taskbar - select Adjust Power Properties - select the Power
Schemes tab and change the settings in Settings for VAIO optimized power scheme).
Using Hibernate mode
The state of the system is saved on the hard disk and power is turned off. Even when the battery runs down, no data will be lost.
The power indicator light is off in this mode.
To activate Hibernate mode, proceed as follows:
Press <Fn>+<F12>.
The Hibernating screen appears and the computer enters Hibernate mode.
Alternatively,
Click Start, and then Turn Off Computer.
In the Turn off computer screen, hold down the <Shift>-key and press Hibernate.
To Next Page
Loading...
