33
The Connection/Power Menu
Adjustments and Settings Using a Menu
*11: The factory default settings for “Access Pt. (Manual)” are as follows.
SSID: VPL + MAC address for LAN
Security Method: WEP(64bit)
Wireless Password: sony1
To change the settings for “Access Pt. (Manual)”, use a Web browser.
For details, see “Setting the WLAN Network of the projector” (page 41).
*12: For changing the settings for “Client,” use the Web browser for change. For details, see
“Setting the WLAN Network of the projector” (page 41).
*13: Constant Brightness mode will be enabled for about 2,000 hours after it is activated at early
usage. After this period, it will be disabled automatically. Activated time and brightness may
vary depending on the usage conditions.
*14: If the projector cannot connect wirelessly, click [Apply] once again to make sure the
connection is established. For details, see “Setting the WLAN Network of the projector”
(page 41).
*15: Does not function when “Type B USB” or “Network” is selected as the input. In this case, it
becomes equivalent to “Standard.” Cannot be selected by VPL-CH355/CH350.
*16: If the image input setting of the HDMI connection equipment is not correct, the brighter part
becomes too bright and the darker part becomes too dark.
*17: The INPUT D connector is available on VPL-CH375/CH355 only.
To Next Page
Loading...
