Sony VPL-HS60 - Board; Lamp Power Supply Board

1-8
VPL-HS60/HS51A
1-4-5. V Board
Removal
1. Remove the base assembly. (Refer to Section 1-3-1.)
2. Remove the rear cover and rear panel.
(Refer to Section 1-3-3.)
3. Remove the two hooks of the rear panel, then remove
the V board.
4. Disconnect the harness from the connector (CN30) on
the V board.
Installation
5. Install the V board in the reverse order of steps 3 and
4.
6. Assemble this unit in the reverse order of steps 1 and
2.
Harness
Hooks
Rear panel
V board
CN30
1-4-6. Lamp Power Supply Board
Removal
1. Remove the cabinet. (Refer to Section 1-3.)
2. Remove the C board.
(Refer to steps 3 to 6 of Section 1-4-1.)
3. Remove the lamp assembly.
(Refer to steps 2 and 3 of Section 1-5-2.)
4. Remove the three screws and disconnect the harness
from the connector (CN14) on the F board, then
remove the lamp power supply unit.
5. Remove the two screws, then remove the lamp house.
6. Loosen the two screws, then remove the connector.
BTP
3 x 12
Lamp
house
Lamp power supply unit
F board
CN14
Harness
Connector
BTP
3 x 12
Screws