33
The Operation Menu
Adjustments and Settings Using a Menu
The Operation Menu
The Operation menu is used for setting for the operations by using the menu or the
remote commander.
*1: You will not be able to use the projector if you forget your password. If you call
qualified Sony personnel because you have forgotten the password, you will be
asked to verify the projector’s serial number and your identity. (This process may
differ in other countries/regions.) Once your identity has been confirmed, we will
provide you with the password.
Setting items
Item descriptions
Language Selects the language used in the menu and on-screen displays.
Menu
Position
Bottom Left/Center: For selecting the position of the menu displayed
on the projected image.
Status On: All on-screen statuses are enabled.
Off: Displays only the menus, the message when turning off the power,
and warning messages.
IR Receiver Front & Rear/Front/Rear: Selects the remote control receiver (IR
Receiver) on the front and rear of the projector.
Security
Lock
*1
On/Off: This function enables restriction of the projector to authorized
users by password. The setting procedures for security locking are as
follows:
1
Select “On” and press the ENTER key to display the setting menu.
2
Input the password with the MENU, /// and ENTER keys.
(The default setting password is “ENTER, ENTER, ENTER, ENTER.”)
3
Input a new password with the MENU, /// and ENTER keys.
4
Enter the password again to confirm.
Enter the password when you turn on the projector after disconnecting
and reconnecting the AC power cord.
When it is set to “Off,” you can cancel the security lock. You are required
to input the password again.
If you fail to enter the correct password after three consecutive times,
the projector cannot be used. In this case, press the / key to go
Standby mode then turn on the power again.
Control Key
Lock
On/Off: When set to “On,” locks all the control panel keys of the
projector. However, you can operate the following when set to “On”:
Press and hold the / key for approximately 10 seconds during
Standby mode.
The projector turns on.
Press and hold the MENU key for approximately 10 seconds during
power on.
“Control Key Lock” is set to “Off” and enables operation of all
keys on the projector.
To Next Page
Loading...
