Sony VPL-PHZ10 - Connection;Power Menu Settings

34
The Connection/Power Menu
The Connection/Power Menu
The Connection/Power menu is used for setting for the connections and power.
Setting items Item descriptions
LAN Settings
IP Address
Setup
*1
Auto (DHCP): The IP address is assigned automatically from
the DHCP server such as a router.
Manual: To specify the IP Address manually.
WLAN Settings
WLAN
Connection
*2
On/Off: Set the wireless output of the USB wireless LAN
module (not supplied) to On/Off.
WLAN
Network
*3
Access Point/Client
*4
: Changes modes for WLAN.
*5
HDBaseT setting Sets the function of the HDBaseT/LAN Port.
HDBaseT/LAN
Port
HDBaseT: Connecting the HDBaseT transmitter and the LAN
cable enables transmitting the signal of the Video, Audio,
Ethernet, and RS-232C.
LAN: Connecting the LAN cable for Ethernet directly enables
connecting to the network.
(Use when connecting the cable directly without the HDBaseT
transmitter.)
RS-232C
setting
Via HDBaseT: You can connect this unit to the RS-232C
terminal via the HDBaseT transmitter. (Baud rate: 9600bps)
RS-232C: Use when connecting to the RS-232C terminal of this
unit directly.
Network Presentation
Connection
CODE
On/Off: This is the presentation function via the network. It
controls the connection using the displayed number (CODE)
on the right bottom of the screen. During the image
transmission, using the ENTER key on the remote commander
makes Connection CODE display again.
Display Setting
LAN Mode Displays the LAN settings of the projector or the
settings of the USB wireless LAN module that
operates as a client at the bottom right of the
screen.
Wired: Displays the IP address of LAN
preferentially.
Wireless: Displays the IP address of the USB
wireless LAN module preferentially.
AP Mode Displays the SSID of the USB wireless LAN
module that operates as an access point at the
bottom right of the screen.