Sony VPL-PHZ10 - Page 35

35
The Connection/Power Menu
Adjustments and Settings Using a Menu
Dynamic Range
*6
Sets the image input level of the INPUT B/C/D terminal.
Auto: Distinguishes the image input level automatically.
Limited: Set when the image input level is 16-235.
Full: Set when the image input level is 0-255.
Input-A Signal Sel. Auto/Computer/Video GBR/Component: When set to
“Auto”, selects the type of video signal input automatically
when “Input-A” is selected.
*7
ECO
Light Output
Mode
Standard/Middle/Low/Auto
*8 *9
: When set to “Standard,” the
image becomes brighter, and power consumption becomes
higher. When set to “Low,” power consumption is minimized;
however, the image will be darker. If you select ”Middle”, the
brightness of the image and power consumption change to
the middle of “Standard” and “Low.” When set to “Auto,”
brightness is adjusted automatically according to image
content. Dark images are projected with brightness adjusted,
leading to energy-saving. Bright images are projected
brightly, without adjusting brightness.
Constant
Brightness
*10
On/Off: Available when Light Output Mode is set to
"Standard" or "Middle." Brightness is constant at about 90% of
light output of each mode.
Auto Power Saving
With No
Input
Light Cutoff: The light turns off automatically
and power consumption is reduced if no signal
is input for approx. 2 minutes. The light lights
again when a signal is input or any key is
pressed. In Light Cutoff, the ON/STANDBY
indicator lights in orange. (page 66)
Standby
*11
: If no signal is input to the unit for
approx. 2 minutes, the power turns off
automatically, and the unit enters standby
mode.
Off: You can deactivate the With No Input.
Setting items Item descriptions