Sony VPL-PHZ10 - Page 47

47
Using Network Features
Network
The factory setting of the security
method and its password are set as
follows.
Security method: WEP 64bit
Password: sony1
(b) Input the settings for Client
Mode.
When the USB wireless LAN
module is activated as a client, set
the items for the client (set the
items for the access point the
projector tries to connect to).
Connection Status:
Displays the connecting status
between the access point and
projector.
SSID:
Input the SSID of access point the
projector tries to connect to.
Encryption Type:
Select the security method of
access point the projector tries to
connect to from the following
list.
Key:
Input the password for security
method of the access point
according to the selected
encryption type as below;
Encyption
Type
Password
Open The password cannot
be input.
WEP 64bit Input 5 ASCII
characters for a
password.
WEP 128bit Input 13 ASCII
characters for a
password.
MIX (WPA-
PSK/WPA2-
PSK (TKIP/
AES)) or
WPA2-PSK
(AES)
Input 8-63 ASCII
characters for a
password.
3-(b)
Encyption
Type
Descriptions
Open Sets the security
method of the access
point to open system
authentication.
WEP 64bit Sets the security
method of the access
point to WEP (64bit).
WEP 128bit Sets the security
method of the access
point to WEP (128bit).
MIX (WPA-
PSK/WPA2-
PSK (TKIP/
AES))
Sets the security
method of the access
point to MIX.
(corresponding to
both WPA-PSK (TKIP/
AES) and WPA2-PSK
(AES) security
methods).
WPA2-PSK
(AES)
Sets the security
method of the access
point to WPA2-PSK
(AES).
Encyption
Type
Password
Open The password cannot
be input.