GB
52
Installation Menu
Network Setting
You can set internet protocols such as IP address, Subnet Mask, Default
Gateway, and DNS Server when accessing the projector from a computer or
using “ImageDirector2” application supplied.
After completing all of settings, select “Apply” using m button, then press
ENTER.
To use the Network setting function,
set “Standby Mode” to “Standard” in the
Function menu.
(1 page 50)
High Altitude Mode Use this item when using the projector at high altitudes.
Off: Use this setting when using the projector at normal altitudes.
On: Use this setting when using the projector at an altitude of 1,500
m or higher.
Note
When this item is set to “On,” the number of turns of the fan
increases.
IP Address Setup Selects either “Auto (DHCP)” or “Manual.”
When you select “Manual,” set the following “IP Address,”
“Subnet Mask,” and “Default Gateway.”
IP Address Sets the IP Address of the projector.
(1.0.0.0 to 223.255.255.255)
Subnet Mask Sets the Subnet Mask of the projector.
(1.0.0.0 to 255.255.255.255)
Default Gateway Sets the Default Gateway of the projector.
(1.0.0.0 to 223.255.255.255)
Primary DNS Sets the DNS server to be used as a priority.
(1.0.0.0 to 223.255.255.255)
Secondry DNS Sets the alternative DNS server.
(1.0.0.0 to 223.255.255.255)
MAC Address Displays MAC address of the projector. You cannot change.
Note
To Next Page
Loading...
