73
GB
Specifications
Others
The preset memory number 44 is available when DDC is set to off on the
computer. However, the screen resolution of the projector may not be
supported, or it is possible that DDC cannot be turned off, depending on the
computer. For details, refer to the operating instructions supplied with your
computer.
DDC (Display Data Channel) allows the computer to obtain information about features
from the monitor. It also allows output of the most appropriate refresh value
automatically, based on the resolution of the monitor.
When a signal other than the preset signals shown above is input, the picture may not
appear properly.
Preset memory numbers for each input signal
Analog signal
Digital signal
Note
Signal Preset memory number
Video signal (VIDEO INPUT and
S VIDEO INPUT connectors)
1, 2
Component signal (INPUT A and Y/C
B/PB/CR/
P
R connectors)
3 to 11
Video GBR signal (INPUT A connector) 3 to 11
Computer signal (INPUT A connector) 21 to 39, 56
Signal Preset memory number
Component signal (HDMI connector) 3 to 8, 10 to 13
Video GBR signal (DVI-D and HDMI
connectors)
3 to 8, 10 to 13
Computer signal (DVI-D connector) 21 to 42, 44, 45, 47, 50, 55 to 57
Computer signal (HDMI connector) 26
To Next Page
Loading...
