19
USER GUIDEUSER GUIDE
USER GUIDEUSER GUIDE
USER GUIDE
Stereo Inputs Compact4Stereo Inputs Compact4
Stereo Inputs Compact4Stereo Inputs Compact4
Stereo Inputs Compact4
These accept 2-pole phono plugs which will automatically ground the ‘cold’ input. Use these
inputs for sources such as keyboards, drum machines, synths, tape machines or as returns from
processing units.
The input is UNBALANCED and you should then keep cable lengths as short as possible to
minimise interference pick-up on the cable.
Stereo Inputs Compact10Stereo Inputs Compact10
Stereo Inputs Compact10Stereo Inputs Compact10
Stereo Inputs Compact10
These accept 3-pole ‘A’ gauge jacks, or 2-pole phono plugs which will automatically ground the
‘cold’ input. Use these inputs for sources such as keyboards, drum machines, synths, tape
machines or as returns from processing units.
The inputs are BALANCED for low noise and immunity from interference, but you can use
UNBALANCED sources by wiring up the jacks as shown, although you should then keep cable
lengths as short as possible to minimise interference pick-up on the cable. Note that the ring must
be grounded if the source is unbalanced.
Mono sources can be fed to both paths by plugging into the Left jack only, and pressing the MONO
switch.
NOTE: Please refer to pages 40/41 for additional wiring details.
Mix Outputs
The Mix outputs are on 3-pole ‘A’ gauge jack sockets, wired as shown on the left, and are balanced,
allowing long cable runs to balanced amplifiers and other equipment.
Monitor Outputs
The Monitor outputs are on 3-pole ‘A’ gauge jack sockets, wired as shown on the left, and are
balanced, allowing long cable runs to balanced amplifiers and other equipment.
Using an InserUsing an Inser
Using an InserUsing an Inser
Using an Inser
t Cablet Cable
t Cablet Cable
t Cable
Shown below is the wiring diagram for an insert cable. Your Soundcraft dealer or local disributor
should also stock this type of cable.
To Next Page
Loading...
