5
USER GUIDEUSER GUIDE
USER GUIDEUSER GUIDE
USER GUIDE
IMPORIMPOR
IMPORIMPOR
IMPOR
TT
TT
T
ANT SAFETY INSTRUCTIONSANT SAFETY INSTRUCTIONS
ANT SAFETY INSTRUCTIONSANT SAFETY INSTRUCTIONS
ANT SAFETY INSTRUCTIONS
CAUTIONS
• Use only the AC adaptor supplied:
UK HB10064 KR HB10067 (C4 ONLY)
EU HB10065 AZ HB10068 (C4 ONLY)
US HB10066 JP HB10069 (C4 ONLY)
Mains voltage selection
This setting is not adjustable. The AC adaptors are capable of operating at either 230V AC or
115V AC +/- 10%. Check the voltage rating of the AC adaptor before plugging in.
Do not use the AC adaptor for any other purpose.
Replace the complete AC adaptor if the plug, lead or adaptor is damaged.
Refer to the Soundcraft dealer from where the equipment was purchased.
The wires in the mains lead are coloured in accordance with the following code:
UK & EUUK & EU
UK & EUUK & EU
UK & EU
US & CANUS & CAN
US & CANUS & CAN
US & CAN
Neutral:Neutral:
Neutral:Neutral:
Neutral: Blue White
Live:Live:
Live:Live:
Live: Brown Black
As the colours of the wires in the mains lead may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows:
The wire which is coloured Blue or White must be connected to the terminal in the plug which is
marked with the letter N.
The wire which is coloured Brown or Black must be connected to the terminal in the plug which is
marked with the letter L.
Ensure that these colour codings are followed carefully in the event of the plug being changed.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
— Consult the dealer or an experienced radio/TV technician for help.
This Class A digital apparatus meets the requirements of the Canadian Interference-Causing
Equipment Regulations.
Cet appareil numérique de la Classe A respecte toutes les exigences du Règlement sur le
matériel brouilleur du Canada.
To Next Page
Loading...
