Symptom
Power does not turn
on.
(No sound is
produced.)
No sound output
when operating the
unit with amplifiers
Cause
Fuse is blown
In
correct wiring
Remedy
Replace with fuse
of
the same amperage.
If the fuse blows again, consult your store
of
purchase
Consult your local retailer.
1.
Turn off the unit.
2.
Remove all wires attached to the
power antenna lead. Check each wire
for a possible short to ground using an
ohm meter.
3.
Turn on the unit.
=
• or power antenna
Power antenna!
lead is shorted to
ground excessive
current is required
or remote on the
amplifiers
or
power
antenna.
4.
Reconnect each amplifier remote wire
to the power antenna lead one by one.
If the amplifiers turn off before all wires
are attached, use an external replay to
provide remote-on voltage (excessive
current required).
Q
(J
attached.
Nothing happens Turn off the power, Then press the [no
when buttons are The microprocessor open] button and remove the DCP. Press
pressed. has malfunctioned the reset button for about
2 seconds with
D
.
1
.
t due to noise, etc. a
thl·n
rod.
ISp
ay
IS
no
Accurate
Panel or main unit
Connectors
are dirty
Compact disc is
Wipe the dirt off with a soft cloth
moistened with cleaning alcohol.
Clean the compact disc without scratches
Sound is bad directly dirty
~~-----------4------------------------~----~
after power is turned Compact disc is
on. heavily scratched
Sound is bad directly
after power is turned
on.
or
warped
Water droplets may
form on the internal
lens when the car is
parked
in
a humid
place
26
Replace with a compact disc without
scratches.
Let it dry for about
1 hour with the power
on.
To Next Page
Loading...
