Sourcetronic ST600 Series - Page 174

Frequency Inverter ST600 Series High-Performance Multifunction VFD Function parameter list
-167-
on delay
P06.13
Relay RO2 switch-
off delay
0.000s
○
P06.14
AO1 output
selection
0: Running frequency (0–Max. output frequency)
1: Set frequency (0–Max. output frequency)
2: Ramp reference frequency (0–Max. output
frequency)
3: Rotational speed (0–Speed corresponding to max.
output frequency)
4: Output current (0–Twice the VFD rated current)
5: Output current (0–Twice the motor rated current)
6: Output voltage (0–1.5 times the VFD rated voltage)
7: Output power (0–Twice the motor rated power)
8: Set torque (0–Twice the motor rated current)
9: Output torque (Absolute value, 0–+/- Twice the motor
rated torque)
10: AI1 input (0–10V/0–20mA)
11: AI2 input (0–10V)
12: AI3 input (0–10V/0–20mA)
13: HDIA input(0.00–50.00kHz)
14: Value 1 set through Modbus/Modbus TCP (0–1000)
15: Value 2 set through Modbus/Modbus TCP (0–1000)
16: Value 1 set through
PROFIBUS/CANopen/DeviceNet (0–1000)
17: Value 2 set through
PROFIBUS/CANopen/DeviceNet (0–1000)
18: Value 1 set through Ethernet 1 (0–1000)
19: Value 2 set through Ethernet 2 (0–1000)
20: HDIB input (0.00–50.00kHz)
21: Value 1 set through EtherCAT/PROFINET/Ethernet
IP (0–1000)
22: Torque current (bipolar, 0–Triple the motor rated
current)
23: Exciting current (bipolar, 0–Triple the motor rated
current)
24: Set frequency (bipolar, 0–Max. output frequency)
25: Ramp reference frequency (bipolar, 0–Max. output
frequency)
26: Rotational speed (bipolar, 0–Speed corresponding
to max. output frequency)
27: Value 2 set through EtherCAT/PROFINET/Ethernet
IP (0–1000)
28: AO1 from the Programmable card (0–1000)
29: AO2 from the Programmable card (0–1000)
30: Rotational speed (0–Twice the motor rated
synchronous speed)
31: Output torque (Actual value, 0–Twice the motor
0
○
P06.15
Reserved
0
○
P06.16
HDO high-speed
pulse output
0
○