Sourcetronic ST600 Series - Page 175

Frequency Inverter ST600 Series High-Performance Multifunction VFD Function parameter list
-168-
rated torque)
32: AI/AO temperature detection output
33–63: Reserved
P06.17
Lower limit of AO1
output
Above function codes define the relation between
output value and analog output. When the output value
exceeds the set max./min. output range, the upper/low
limit of output will be adopted during calculation.
When analog output is current output, 1mA corresponds
to 0.5V voltage. In different applications, 100% of output
value corresponds to different analog outputs.
10V (20mA)
0.0% 100.0%
AO
Setting range of P06.17: -300.0%–P06.19
Setting range of P06.18: 0.00V–10.00V
Setting range of P06.19: P06.17–300.0%
Setting range of P06.20: 0.00V–10.00V
Setting range of P06.21: 0.000s–10.000s
0.0%
○
P06.18
Corresponding
AO1 output of
lower limit
0.00V
○
P06.19
Upper limit of AO1
output
100.0%
○
P06.20
Corresponding
AO1 output of
upper limit
10.00V
○
P06.21
AO1 output filter
time
0.000s
○
P06.22
Reserved
/
/
/
P06.23
PTC constant
output current
setting
0.000~20.000mA
4.000 mA
○
P06.24
PTC resistance
alarm threshold
0~60000Ω
750Ω
○
P06.25
PTC resistance
alarm recovery
threshold
0~60000Ω
150Ω
○
P06.26
Actual PTC
resistance
0~60000Ω
0Ω
●
P06.27
Lower limit of HDO
output
-300.0%–P06.29
0.00%
○
P06.28
Corresponding
HDO output of
lower limit
0.00–50.00kHz
0.00kHz
○
P06.29
Upper limit of HDO
output
P06.27–300.0%
100.0%
○
P06.30
Corresponding
HDO output of
upper limit
0.00–50.00kHz
50.00
kHz
○