Sourcetronic ST600 Series - Page 199

Frequency Inverter ST600 Series High-Performance Multifunction VFD Function parameter list
-192-
stall
P11.24
Integral coefficient
of current regulator
during overvoltage
stall
0–2000
250
○
P11.25
Enable VFD
overload integral
0: Disable
1: Enable
0
◎
P11.26
Reserved
/
/
/
P11.27
VF vibration
control method
0x00–0x11
Ones place:
0: Method 1
1: Method 2
Tens place:
0: Reserved
1: Reserved
0x00
◎
P11.28
SPO switch-on
detection delay
time
0.0–60.0s
Note: The SPO detection is started only after the VFD
runs for the delay time P11.28 to advoid false alarms
caused by the unstable frequency.
5.0s
○
P11.29
SPO unbalance
factor
0–10
6
○
P11.30
Reserved
/
/
/
P11.31
Fault severity
group 1
0x0000–0x3333
Thousands place/Hundreds place/Tens place/Ones
place:
0: Report the fault
1: Report the fault after deceleration to stop
2: Pre-alarm, with the action executed according to
P11.51
3: Screen out the fault
Note: Different fault actions are taken for different fault
severities. The first 10 faults are not grouped by
severity, but each four of the subsequent faults are
grouped by severity in ascending order from right to left
in hexadecimal format, that is, from the ones place to
the thousands place (for example, the ones place of
fault severity group 1 corresponds to fault 11).
Group 1: Faults 11–14 (OL1, OL2, SPI, SPO)
Group 2: Faults 15–18 (OH1, OH2, EF, CE)
Group 3: Faults 19–22 (ItE, tE, EEP, PIDE)
Group 4: Faults 23–26 (bCE, END, OL3, PCE)
Group 5: Faults 27–30 (UPE, DNE, E-DP, E-NET)
Group 6: Faults 31–34 (E-CAN, ETH1, ETH2, dEu)
Group 7: Faults 35–38 (STo, LL, ENC1o, ENC1d)
0x0000
○
P11.32
Fault severity
group 2
0x0000
○
P11.33
Fault severity
group 3
0x0000
○
P11.34
Fault severity
group 4
0x0000
○
P11.35
Fault severity
group 5
0x0000
○
P11.36
Fault severity
group 6
0x0000
○
P11.37
Fault severity
group 7
0x0000
○
P11.38
Fault severity
group 8
0x0000
○
P11.39
Fault severity
group 9
0x0000
○
P11.40
Fault severity
group 10
0x0000
○