Sourcetronic ST600 Series - Page 217

Frequency Inverter ST600 Series High-Performance Multifunction VFD Function parameter list
-210-
0x00–0x0F
Corresponds to R02, RO1, HDO and Y1 respectively
P17.14
Digital adjustment
variable
Display the regulating variable by UP/DOWN
terminals of the VFD.
Range: 0.00Hz–P00.03
0.00Hz
●
P17.15
Torque reference
value
Relative to percentage of the rated torque of current
motor, display torque reference.
Range: -300.0%–300.0% (rated motor current)
0.0%
●
P17.16
Linear speed
0–65535
0
●
P17.17
Reserved
/
/
/
P17.18
Count value
0–65535
0
●
P17.19
AI1 input voltage
Display input signal of AI 1
Range: 0.00–10.00V
0.00V
●
P17.20
AI2 input voltage
Display input signal of AI2
Range: -10.00V–10.00V
0.00V
●
P17.21
HDIA input frequency
Display input frequency of HDIA
Range: 0.000–50.000kHz
0.000
kHz
●
P17.22
HDIB input frequency
Display input frequency of HDIB
Range: 0.000–50.000kHz
0.000 kHz
●
P17.23
PID reference value
Display PID reference value
Range: -100.0–100.0%
0.0%
●
P17.24
PID feedback value
Display PID feedback value
Range: -100.0–100.0%
0.0%
●
P17.25
Motor power factor
Display the power factor of current motor.
Range: -1.00–1.00
0.00
●
P17.26
Current running time
Display current running time of the VFD.
Range: 0–65535min
0min
●
P17.27
Actual stage of
simple PLC
Displays the present stage of the simple PLC function.
0
●
P17.28
Motor ASR controller
output
Display the speed loop ASR controller output value
under vector control mode, relative to the percentage
of rated torque of the motor.
Range: -300.0%–300.0% (rated motor current)
0.0%
●
P17.29
Pole angle of open-
loop synchronous
motor
Display initial identification angle of synchronous
motor
Range: 0.0–360.0
0.0
●
P17.30
Phase compensation
of synchronous motor
Display phase compensation of synchronous motor
Range: -180.0–180.0
0.0
●
P17.31
High-frequency
superposition current
of synchronous motor
0.0%–200.0% (rated motor current)
0.0
●