If machine doesn’t turn on,
turn power OFF, wait 30 minutes,
and repeat steps 1 to 5. If problem
persists, contact service team.
If machine makes any
abnormal noise during reset,
immediately switch power OFF
and contact service team.
-(usually
because the viscosity is set too high for the selected product) to prevent motor damage. Use
the green reset buon to return the machine to normal operaon.
1. Switch power switch OFF.
2. Press green reset buon on side or
back of machine.
3. Wait 15 to 20 minutes; switch power
ON.
4. Press RESET, then WASH buon on
front.
5. Observe machine performance and
return to normal use if funconing
properly.
Make only small adjustments to viscosity seng; allow at least 10 to 15 minutes
between adjustments to evaluate product rmness. Viscosity seng should NOT need
connuous adjustment. A seng of 3 is a good starng point for most product.
Machines without air pumps can experience product consistency changes if they go unused for an ex-
tended period of me. Product may become icy or dense if le in the freezing cylinder too long, oen
occurring during a business’s longer slow-periods.
1. With machine in FREEZE mode, remove air tube.
2. Clean air tube and insert into machine upside-down (inlet hole on the side of the air tube at the top).
3. Conrm product is above low-mix line in hopper.
4. Open draw handle to draw 170 g to 227 g (6 oz. to 8 oz.) of product; discard product.
5. Wait unl machine nishes freeze cycle and motor stops turning.
6. Remove and clean air tube.
7. Insert air tube into machine with correct orientaon (inlet hole on the side of the air tube at the
boom).
8. Machine is ready for normal operaon.
Take O Faceplate
Control Board and Dip Switches
1. Take o faceplate cover by unscrewing le and right
screws from below.
2. Viscosity is adjusted on the Electronic Control Board.
3. Move the switch UP for the desired viscosity level.
Move all other switches DOWN.
4. Viscosity is from Harder to Soer from level 1 - 6.
To Next Page
Loading...
