1. Inadequate mix in hopper.
2. Hopper temperature seng is too low.
Ensure hopper is at least half full.
1. Improper or inadequate lubricaon of
beater seal.
2. Damaged, missing, or improperly installed
beater.
1. Use sucient food-grade lubricant, and add
sucient lubricant inside gasket during
assembly (Page 9).
2. Replace beater seal every 1 to 3 months.
1. Machine isn’t cleaned/lubricated adequately.
2. Inadequate mix in hopper.
3. Improper mixing of product.
4. Machine doesn’t have adequate venlaon.
5. Viscosity adjustment is set incorrectly.
1. Clean and properly lubricate machine daily.
2. Ensure hopper is at least half full.
3. Follow manufacturer instrucons for mixing
product; ensure correct mix raos.
4. Ensure a minimum 152mm (6'') clearance on
exhaust sides.
5. Raise viscosity seng as required (Page 12).
1. Warm product was recently added.
2. Hopper temperature seng is too high.
3. Temperature osets need adjustment.
1. Allow at least 1 hour aer adding new mix
for hopper temperatures to stabilize.
2. Call Spaceman Technical Support.
1. Improper assembly.
2. Wearable parts need replacement.
3. Internal cleaning/maintenance required.
4. Damaged internal parts.
1. Stop machine use, drain product with
machine powered OFF; clean and inspect
parts.
2. Replace wearable parts at least once every
3 months.
3. Contact Spaceman Technical Support.
4. Inspect parts carefully for damage, ensure
proper assembly; replace as required.
To Next Page
Loading...
